Firstly, after turning on the incoming water source and connecting the power supply, the ultra-pure water equipment can work fully automatically to make water; secondly, if you need to take RO reverse osmosis water, DI deionised water, turn on the corresponding left and right sides to take the water ball valve; finally, after taking the water to close the zone water port, the equipment will automatically stop, at this time, open any water port, it will automatically restart and make pure water, so as to cycle and make the required pure water.
Note: If not in use for a long period of time or before leaving work, be sure to turn off the power to the water purifier and cut off the tap water source to avoid accidents. Tap water as the source of water system, the requirements of the incoming water pressure to meet the requirements of the equipment, the diameter of the incoming water pipe shall not be less than the specified size.
The above is the introduction to the use of ultrapure water equipment, if you have other questions, you can leave a message at the end of the article, I will reply to you in a timely manner!
