1. The phenomenon of "running resin" occurs when producing water, you can put the resin into the water softening tank, open the resin tank, take out the central tube and check, if damaged, replace the central tube, and if the water distributor is damaged, replace it.
2. When regenerating the "running resin" phenomenon, you can first reduce the flow rate of the backwash water to see if it is the reason for the high pressure of the incoming water, the general backwash flow rate is around 10~15m/h. If it is not a flow rate problem, you need to open the water softener tank and check if the upper water cloth is damaged.
3. If the resin layer contains air, you need to stop backwashing immediately, open the water inlet to feed the water, wet the floating resin and wait for the resin layer to be fully implemented before backwashing.
The above is to prevent the resin is washed out of the tank hair method introduction, if you have other questions, you can leave a message at the end of the article, I will promptly reply to you!
