1. Before we use the equipment, we need to open the brine tank cover of the softened water equipment and visually check the salt level. Remember, do not let the salt level be lower than 1/3 of the height of the brine tank. Before adding salt again, do not use up all the salt in the brine tank. As for how much salt to add, you can add it appropriately, but make sure that when the salt is sucked replenish water will not be full out of your brine tank.
2. In the softened water equipment in use, it is necessary to regularly add special salt to renew the resin, because salt water is required for each regeneration, and the water used to dissolve the salt is injected quantitatively by the softened water equipment, and at the same time, it is necessary to ensure that the salt tank has been stored in a sufficient amount of salt.
3. Fill the brine tank of the softened water equipment with granular or pellet-shaped water softener salt. Do not use rock salt, as rock salt contains impurities and sediments that can cause the device to not work properly.
